Table of Contents
Advertisement
NOTE:
To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.
Steps
1
Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin end of the
card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
Next step
Follow the procedure listed in
Removing the optional IDSDM or vFlash card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable, remove the rear drive cage.
4
If applicable, remove the full-height PCIe card.
5
If you are replacing the IDSDM/vFlash card, remove the MicroSD cards.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
154
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Hide quick links:
Advertisement
Table of Contents
