Table of Contents
Advertisement
Figure 55. Installing the heat sink
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in the
Optional IDSDM or vFlash module
The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the optional IDSDM or vFlash card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air shroud.
4. If you are replacing the IDSDM/vFlash card,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Next steps
NOTE:
If you are replacing the IDSDM or vFlash module, remove the MicroSD cards.
1.
Replace the IDSDM/vFlash module.
Installing optional IDSDM or vFlash card
Prerequisites
1. Follow the safety guidelines listed in the
56
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
remove the MicroSD
Safety
instructions.
system.
system.
cards.
Advertisement
Table of Contents
