Removing Expansion Card Riser 3 - Dell PowerEdge R740xd Installation And Service Manual

3 If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
4 Follow the procedure listed in
5 Install any device drivers required for the card as described in the documentation for the card.
Related link
Installing the air shroud
Installing expansion card into expansion card riser

Removing expansion card riser 3

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
NOTE: If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4 If installed, remove expansion cards installed on the riser.
5 Disconnect any cables connected to the riser card.
Steps
1 Using Phillips #2 screwdriver, loosen the screw that secures the riser to the system.
2 Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
Figure 93. Removing expansion card riser 3
Next step
Install the expansion card riser 3.
Related link
Installing expansion card riser 3
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 143