Optional Idsdm Or Vflash Module; Removing The Optional Idsdm Or Vflash Card - Dell PER4402A Installation And Service Manual

Figure 77. Installing the MicroSD card
Next steps
Follow the procedure listed in

Optional IDSDM or vFlash module

Removing the optional IDSDM or vFlash card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If you are replacing the IDSDM/vFlash card, remove the MicroSD cards.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
2. Holding the pull tab, lift the IDSDM/vFlash card out of the system.
82 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.