Optional Idsdm Or Vflash Module; Removing The Optional Idsdm Or Vflash Card; Installing Optional Idsdm Or Vflash Card - Dell EMC PowerEdge R240 CHRH4 Installation And Service Manual

Table of Contents

Advertisement

Optional IDSDM or vFlash module

The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE:
The write-protect switch is on the IDSDM or vFlash module.

Removing the optional IDSDM or vFlash card

Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air shroud.
4
If you are replacing the IDSDM/vFlash card,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into the
corresponding slots.
Step
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Next step
NOTE:
If you are replacing the IDSDM or vFlash module, remove the MicroSD cards.
1
Replace the IDSDM/vFlash module.

Installing optional IDSDM or vFlash card

Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the air shroud.
Steps
1
Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see
connectors
section.
2
Align the IDSDM/vFlash card with the connector on the system board.
3
Push the IDSDM/vFlash card until it is firmly seated on the system board.
Safety
instructions.
Before working inside your
remove the MicroSD
Safety
instructions.
Before working inside your
system.
cards.
system.
Installing and removing system components
System board jumpers and
85

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emc poweredge r240

Table of Contents