Table of Contents
Advertisement
Figure 150. Installing system board
Next steps
1
Install the Trusted Platform Module (TPM).
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module will be provided for all system board replacements where a TPM plug-in module was installed.
2
Replace the following:
a
Mid drive tray (if applicable)
b
Rear drive cage (if applicable)
c
Integrated storage controller card
d
Internal USB key (if applicable)
e
iDSDM/vFlash card
f
All expansion card risers
g
Processor and heat sink module
h
Processor and DIMM blank
i
Memory modules and memory module blanks
j
Network daughter card
k
Cooling fan assembly
l
Air shroud
m
Power supply unit(s)
3
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4
Follow the procedure listed in
5
Ensure that you:
a
Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b
If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Entering the Service Tag section.
c
Update the BIOS and iDRAC versions.
d
Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the Trusted Platform Module (TPM)
section.
6
Import your new or existing iDRAC Enterprise license.
194
Installing and removing system components
After working inside your
system.
Hide quick links:
Advertisement
Table of Contents
