Removing Riser 2 And 3 Blank - Dell PowerEdge R740xd Installation And Service Manual

Figure 82. Installing expansion card into expansion card riser 3
Next steps
1 If applicable, connect the cables to the expansion card.
2 If applicable, install the air shroud.
3 Follow the procedure listed in
4 Install any device drivers required for the card as described in the documentation for the card.
Related link
Opening and closing the PCIe card holder latch
Installing the air shroud

Removing riser 2 and 3 blank

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Steps
1 Using Phillips #2 screwdriver, loosen the screws (3) that secure the blank to the system.
2 Press the release tab, and holding the blank by its edges, lift the blank away from the system.
134 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.