Removing The Optional Idsdm Or Vflash Card; Installing Optional Idsdm Or Vflash Card - Dell E30S002 Manual

Removing the optional IDSDM or vFlash card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see the System board jumpers and connectors section.
2 Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Figure 62. Removing the optional IDSDM/vFlash card
NOTE: There are two dip switches on the IDSDM/vFlash card for write-protection.
Next step
Install the optional IDSDM/vFlash card.
Related link
System board jumpers and connectors
Removing the air shroud

Installing optional IDSDM or vFlash card

Installing optional IDSDM or vFlash card
Prerequisite
Follow the safety guidelines listed in
114 Installation and Service Manual
Installing and removing system components
Safety instructions.
Before working inside your
Safety instructions.
system.