Optional Idsdm Or Vflash Module; Removing The Optional Idsdm Or Vflash Card - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 68. Installing the MicroSD card
Next steps
Follow the procedure listed in

Optional IDSDM or vFlash module

Removing the optional IDSDM or vFlash card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Install the air shroud.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
2. Holding the pull tab, lift the IDSDM/vFlash card out of the system.
After working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 81