Opening And Closing The Pcie Card Holder Latch - Dell PowerEdge R740xd Installation And Service Manual

NOTE: For information about slot form factor, see the Expansion card riser configurations
table.
NOTE: The expansion card slots are not hot-swappable.
NOTE: Double width GPUs are supported only on riser configuration 4, and single width GPUs are supported only on riser
configuration 6.
NOTE: Ensure that x16 cards are installed only in x16 slots. Depending on the riser configuration slots 2, 7, or 8 may not be
available.
NOTE: Only half length PCIe cards are supported on riser 2 when NVDIMM-Ns with NVDIMM-N battery are installed on the air
shroud.
NOTE: For 24x2.5 inch 24 NVMe drive configuration, the PCIe bridge cards must be installed in slots 3 and
4.

Opening and closing the PCIe card holder latch

Before installing or removing a full length PCIe card, the PCIe card holder latch must be closed. When the full length PCIe card is installed,
open the PCIe card holder latch.
Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Steps
1 To open the PCIe card holder latch, press the release tab.
Figure 73. Opening the PCIe card holder latch
2 To close the PCIe card holder latch, push the latch until it locks.
128 Installing and removing system components
Safety instructions.
Before working inside your system.