Removing Nvdimm-N Battery From Mid Drive Tray - Dell PowerEdge R740xd Installation And Service Manual

Figure 34. Installing NVDIMM-N battery into air shroud
Next step
Follow the procedure listed in

Removing NVDIMM-N battery from mid drive tray

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
CAUTION:
that your system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before
removing the NVDIMM-N battery.
CAUTION:
removing a battery.
Steps
1 Lift the drive tray handles 90 degrees upward.
2 Using Phillips #2 screwdriver, remove the screw securing the NVDIMM-N battery.
3 Slide the NVDIMM-N battery to disengage it from the drive tray.
4 Disconnect the cables from the NVDIMM-N battery.
5 Holding the edges, lift the NVDIMM-N battery away from the system.
84 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure
To avoid damage to the battery connector, you must firmly support the connector while installing or
system.
system.