3. Button:
MENU
DOWN
UP
ENTER
4. POWER IN/OUT:
5. Only for remote control:
6. Fuse (T 3.15A):
7. DMX IN/OUT:
For DMX512 links, use 3‐pin XLR plug cable to link the unit together;
3.2 Main Function
To select any functions, press the MENU button until the required function is showing on the
display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup to go back to the functions without any changes press the MENU button
again. Hold and press the MENU button for one second or wait for one minute to exit the menu
mode.
The main functions are shown below:
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
Used to connect to supply power;
Used to connect to the optional CA‐8 to control the unit for Stand
by, Function and Mode function;
Used to protect the unit from the damage of over‐current;
5A