Main Function - ACME Ellipsoidal E-300 D2550 User Manual

3．LED:
MASTER
SLAVE
DMX
4．MAINS OUT: PowerCon loop connection for main power supply to the next unit;
5．MAINS IN: PowerCon connection from main power supply;
6．DMX IN: For DMX512 link, use 5-pin XLR cable to link the unit and the DMX controlle
7．DMX IN: For DMX512 link, use 3-pin XLR cable to link the unit and the DMX controlle
8．DMX OUT: For DMX512 link, use 5-pin XLR cable to link the next unit and output DMX signal;
9．DMX OUT: For DMX512 link, use 3-pin XLR cable to link the next unit and output DMX signal;
10. RJ 45 Socket: No function at the moment. Reserve for Art-net in the future.
11. Fuse (T 6.3A): To protect the unit from damage of over current;
12. POWER SWITCH: Turns On/off the power;
13. Button:
MENU
DOWN
UP
ENTER

6. Main Function

To select any functions, press the MENU button until the required function is showing on the
display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup to go back to the functions without any changes press the MENU button
again. Hold and press the MENU button for one second or wait for one minute to exit the menu
mode.
The main functions are shown below:
On
On
On
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
Master Mode
Slave Mode
DMX input present
8E
r;
；
r