Introduction Thank you for purchasing Junior Series, the unit is a powerful 100W effect lights, Plug & play and easy to use, any where enjoys the pleasurable light show. Selector switch for 3 sets of auto, sound activation or static function mode to dynamic emotion applications. Junior series without any duty cycle, equip with super cooling fan built up a fantastic light show to dancing all night.
Safety Instruction Please read carefully the instruction which includes important information WARNING about the installation, usage and maintenance. Please keep this User Manual for future consultation. Unpack and check carefully there is no transportation damage before using the unit. ...
Page 6
Warning To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture. Never touch bulb with bare fingers as it is very hot after using. Hot lamp explosion hazard. Do not open the unit within five minutes after switching off. ...
Description 1. Optical lens with manual focus adjustment 2. Hanging bracket with one knob to fasten the unit 3. Power cord comet only to a matching power outlet 4. Build-in fuse 5. Lamp accessory door 6. Internal microphone 7. Cooling fan 8.
Operation and Technical Specification • Plugging into the mains power and it will start running. The unit runs in automatic, sound activated or static mode. • Focus adjustable by manual. Specification: • Voltage: AC 120V 60Hz (US) AC 230V /240V /250V 50Hz / 60Hz (EU) •...
Exchange Lamp DANGER! In case of replacement of the lamp, do not open the lamp accessory door within 15 minutes until the unit cools down after switching off. LAMP: EFP 12V 100W 1. Always switch off the main supply and never handle the lamp or luminaries when is hot. 2.
Page 10
3. Take off the lamp with carefully 4. Replace the new lamp 5. Push gently with thumb and make sure the lamp was located on the central zone with tight for best light effects. 6.Reverse step 2 to step 1.
Exchanging Rotating Gobos Warning: the function for Junior-Fascination only! DANGER! Install the gobo when the power is off for 15 minutes only. If you wish to use other patterns as the standard-gobo, please follow the below steps with carefully. 1. Unscrew the screw from the lamp accessory door 2.
Page 12
4. Notice the front and reverse side! 5. Remove steel ring from front side then take off the gobo 6. Exchange to new gobo and fasten with steel ring 7. CAUTION! Please make sure the gear wheel is correct 8. Reverse step 2 to step 1...
Exchange Fuse DANGER! In case of replacement of fuse, please awaiting 15 minutes until the unit cools down after switching off. 1. Push and rotate with arrow by thumb 2. Remove the protect tube of fuse 3. Exchange new fuse with same model 4.
Troubleshooting Problem Feature Remedy No power to the fixture Check power connections please check and replace fuse if Fuse power is on No light Burned out of lamp Install new lamp Allow to cool down and improve air Fixture too hot flow around the unit Sound sensitivity Increase volume...
Fixture Cleaning The cleaning of internal and external optical lenses or mirror must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit’s optics.