Subscribe to Our Youtube Channel
Related Manuals for ACME LED-7TC
Summary of Contents for ACME LED-7TC
-
Page 1: User Manual
LED PANEL LED-7TC User Manual Please read the instructions carefully before use Innovation, Quality, Performance... - Page 2 9. Fixture Cleaning The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or TABLE OF CONTENTS particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s optics. Clean with soft cloth using normal glass cleaning fluid.
-
Page 3: Troubleshooting
8. Troubleshooting 1. Safety Introductions Following are a few common problems that may occur during operation. Here are some Please read the instructions carefully which includes important suggestions for easy troubleshooting: information about the installation, operation and maintenance. WARNING A. The fixture does not work, no light Please keep this User Manual for future consultation. -
Page 4: Dmx512 Connections
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or 7. DMX512 Connections moisture. The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. Do not open the unit within five minutes after switching off. The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged. -
Page 5: How To Set The Unit
4. How To Set The Unit Blackout To blackout all the fixture Function Strobe Select Color Select show Select Chase 4.1 Control Panel 1. Synchronous strobe in white color Color 1-16 or Show 1-12 Chase 1-16 or fade 2. The same color chase manual setting 3. -
Page 6: How To Control The Fixture
4.2 Main Function Software version To select any of the given functions, press the MENU button up to the required one is shown on the display. Select the function by ENTER button and the display will blink. Use DOWN Press the MENU button up to when the is blinking on the display. - Page 7 Led Display Press the MENU button up to when the is shown on the display. Pressing ENTER button and the display will blink. Use DOWN and UP button to select the (Led on) (Led off) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds.
- Page 8 DMX 512 Address Setting Slave Mode Press the MENU button up to when the is shown on the display. Press ENTER Press the MENU button up to when the is shown on the display. Pressing ENTER button and the display will blink. Use DOWN and UP button to change the DMX512 address. button and the display will blink.
Need help?
Do you have a question about the LED-7TC and is the answer not in the manual?
Questions and answers
Hello, I have 4 units of ACME LedPanel 7tc...if i only use color manuel, it close after few seconds and yellow light Master mode open...why ?...can they satyre open ? Also, i use it for a band, i would like tu use it with sound active...following beat of the music. Regards
The ACME LED-7TC may close after a few seconds in color manual mode if it is receiving a DMX signal, which can override manual settings. To keep it open in color manual mode, ensure it is not connected to a DMX controller or set the proper DMX address.
To use the fixture in sound active mode and follow the beat of the music:
1. Ensure the fixture is not receiving a DMX signal.
2. Set the mode to “Sound” mode using the control panel.
3. Use “Sound 1” for manual sound mode (LED ON) or “Sound 2” for auto sound mode (LED blinking).
4. Check the microphone by tapping it to confirm it is functioning.
This allows the fixture to react to music beats.
This answer is automatically generated