ACME SAMBA Color User Manual page 8

DMX Address
To select the DMX Address, press the ENTER button to show DMX ADDRESS on the display. Use
the DOWN/UP button to adjust the address from 001 to 512. Once the address has been selected,
press the ENTER button to setup, to go back to the functions without any changes press the MENU
button again. Hold and press the MENU button for one second or wait for one minute to exit the
menu mode.
Channel Mode
To select the Channel Mode, press the ENTER button to show the CHANNEL MODE on the display.
Use the DOWN/UP button to select the 1, 7, 13, 37 channel modes. Once the mode has been
selected, press the ENTER button to setup, to go back to the functions without any changes press
the MENU button again. Hold and press the MENU button for one second or wait for one minute
to exit the menu mode.
Slave Mode
To select the Slave Mode, press the ENTER button to show SLAVE MODE on the display. Use the
DOWN/UP button to select the Master, Slave 1, or Slave 2 modes. Once the mode has been
selected, press the ENTER button to setup, to go back to the functions without any changes press
the MENU button again. Hold and press the MENU button for one second or wait for one minute
to exit the menu mode.
Show Mode
To select the Show Mode, press the ENTER button to show the SHOW MODE on the display. Use
the DOWN/UP button to select the Show 1, Show 2, Show 3 or Show 4 Mode. Once the mode has
been selected, press the ENTER button to setup, to go back to the functions without any changes
press the MENU button again. Hold and press the MENU button for one second or wait for one
minute to exit the menu mode.
Sound State
To select the Sound State, press the ENTER button to show SOUND STATE on the display. Use the
DOWN/UP button to select the On (sound on) or Off (sound off) mode. Once the mode has been
7A