constantly lit.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the
1/4" microphone jack of the first unit, you will find that the remote controller on the
first unit will control all the other units for Stand by, Function and Mode selection.
Blackout
Blackout the unit
1. Sound Strobe (Full On)
Function
2. Auto Strobe (Full On)
Random Show
Mode
(LED OFF)
4.3 DMX Address Setting
To set the DMX address, press the MENU button to show DMX Address on the display. Press the
ENTER button and the display will blink. Use the DOWN and UP button to change the DMX
address. Once the address has been selected, press the ENTER button to setup, to go back to the
functions without any change press the MENU button again. Hold and press the MENU button
for one second or wait for one minute to exit the menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel Mode
1 channel
7 channels
13 channels
37 channels
Select Show
Show 1‐4
Show
(LED ON)
Unit 1
Unit 2
1
2
1
8
1
14
1
38
11A
Unit 3
Unit 4
3
4
15
22
27
40
75
112
.