Safety Instructions - ACME SAMBA Color User Manual

1. Safety Instructions
Please read the instructions carefully which includes important information
WARNING
PLEASE keep this User Manual for future consultation. If you sell the fixture to another user,
make sure that they also receive this instruction booklet.
PLEASE unpack and check carefully there is no transportation damage before using the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
PLEASE disconnect mains power before servicing and maintenance.
Maximum ambient temperature is Ta: 40℃. DO NOT operate it where the temperature is
higher than this.
Unit's surface temperature may reach up to 85℃. DO NOT touch the housing bare‐handed
during its operation.
In the event of serious operating problem, stop using the fixture immediately. Never try to
repair the fixture by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always use the
same type spare parts.
DO NOT connect the device to any dimmer pack.
DO NOT touch any wire during operation and there might be a hazard of electric shock.
The housing must be replaced if they are visibly damaged.
Warning
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
For 230V 50Hz power supply, maximum fixtures that can be connected together from
the same mains outlet is 8pcs;
For 120V 60Hz power supply, maximum fixtures that can be connected together from
the same mains outlet is 5pcs;
about the installation, operation and maintenance.
2A