How To Control The Unit; Master/Slave Built In Preprogrammed Function - ACME SAMBA Color User Manual

wait for one minute to exit the menu mode.
Software Version
To select the Software Version, press the ENTER button to show SOFTWARE VERSION on the
display and the display will show the version of software of the unit. To go back to the functions
without any changes press the MENU button again. Hold and press the MENU button for one
second or wait for one minute to exit the menu mode.
Reset
To select the Reset, press the ENTER button to show RESET on the display. Press the ENTER button
and all channels of the unit will return to their standard position.
4. How to Control the Unit
You can operate the unit in three ways:
1. By master/slave built‐in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be affected at once. Each time you turn the unit on, it will show "MB8FC" on the display. After that
the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units together in master/slave, the first unit (the master) will control the other units
(the slave) to give an automatic, sound activated, synchronized light show. This function is good
when you want an instant show.
To set the first unit as a master, press the ENTER button to show the SHOW MODE on the display.
Now use the DOWN and UP buttons up to select the Show 1, Show 2, Show 3 or Show 4 and the
master LED will be constantly lit and the sound LED will flash to the music. To set the unit as a
slave, press the ENTER button to show SLAVE MODE on the display. Now use the DOWN and UP
buttons up to select Slave 1 (normal) and Slave 2(2 light show) mode, and the SLAVE LED will be
10A