How To Configure Site-To-Site Ipsec Vpn With A Sonicwall Router; Set Up The Ipsec Vpn Tunnel On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook

4.6 How to Configure Site-to-site IPSec VPN with a
SonicWALL router
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN between a
ZYWALL/USG and a SonicWALL router. The example instructs how to configure the VPN tunnel
between each site. When the VPN tunnel is configured, each site can be accessed securely.
Figure 325 ZyWALL/USG Site-to-site IPSec VPN with SonicWALL
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks.
This example was tested using USG310 (Firmware Version: ZLD 4.13) and
NSA240 (Firmware Version: SonicOS Enhanced 5.8.0.1-31o)

4.6.1 Set Up the IPSec VPN Tunnel on the ZyWALL/USG

In the ZyWALL/USG, go to CONFIGURATION > Quick Setup > VPN Setup Wizard, use the VPN
1
Settings wizard to create a VPN rule that can be used with the SonicWALL. Click Next.
Figure 326 Quick Setup > VPN Setup Wizard > Welcome
Choose Advanced to create a VPN rule with the customize phase 1, phase 2 settings and
2
authentication method. Click Next.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
142