Set Up The Ipsec Vpn Tunnel On The Zywall/Usg By Using Vpn Concentrator; Hub_Hq-To-Branch_A - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.13).
4.8.1 Set Up the IPSec VPN Tunnel on the ZyWALL/USG by Using VPN
Concentrator
4.8.2 Hub_HQ-to-Branch_A
In the ZyWALL/USG, go to CONFIGURATION > Quick Setup > VPN Setup Wizard, use the VPN
1
Settings wizard to create a VPN rule that can be used with the remote ZyWALL/USG. Click Next.
Figure 375 Quick Setup > VPN Setup Wizard > Welcome
Choose Express to create a VPN rule with the default phase 1 and phase 2 settings and use a pre-
2
shared key to be the authentication method. Click Next.
Figure 376 Quick Setup > VPN Setup Wizard > Welcome > Wizard Type
Type the Rule Name used to identify this VPN connection (and VPN gateway). You may use 1-31
3
alphanumeric characters. This value is case-sensitive. Select the rule to be Site-to-site. Click
Next.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
164
Advertisement
Table of Contents
