Set Up The Anti-Virus Profile On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook

Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.13).

3.11.1 Set Up the Anti-Virus Profile on the ZyWALL/USG

In the ZyWALL/USG, go to CONFIGURATION > UTM Profile > Anti-Virus > Black/White List
1
> Black List, click the Add icon. Use wildcards (*) to configure File Pattern.
Figure 199 CONFIGURATION > UTM Profile > Anti-Virus > Black/White List > Black List > Add rule
Go to CONFIGURATION > UTM Profile > Anti-Virus > Black/White List > Black List >
2
General Settings to select Enable Black List.
Figure 200 CONFIGURATION > UTM Profile > Anti-Virus > Black/White List > Black List > General
Settings
In the ZyWALL/USG, go to CONFIGURATION > UTM Profile > Anti-Virus > Profile > Profile
3
Management > Add rule and configure a Name for you to identify the Anti-Virus Profile.
Select Log type to be log alert in order to view the result later.
Make sure you select Check Black List and click OK.
Chapter 3 Protect Your Network with UTM
ZyWALL/USG Series User's Guide
95