Test The Result - ZyXEL Communications ZyWALL 110 Handbook

Figure 21 CONFIGURATION > Network > Interface > Trunk > User Configuration > Add Trunk
In the Configuration screen, go to Default WAN Trunk section, select User Configured Trunk
3
and select the newly created Trunk from the list box. Click Apply.
Figure 22 CONFIGURATION > Network > Interface > Trunk > Default WAN Trunk > User
Configured Trunk

1.2.3 Test the Result

Check the Interface Statistics when wan1 and wan2 connections are up. You can see both wan1
1
and wan2 Status are up, Tx B/s displays the transmission speed and Rx B/s displays the
reception speed; cellular1 Status is connected but there is no traffic going through this interface.
Figure 23 MONITOR > Interface Status > Interface Statistics
After disconnecting both wan1 and wan2, you can see both wan1 and wan2 Status are Down and
2
no traffic goes through these two interfaces. The backup cellular1 Status is connected and all the
traffic is going through this interface.
Chapter 1 Set Up Your Network
ZyWALL/USG Series User's Guide
24