Set Up The 6To4 Tunnel On The Zywall/Usg; Test The Result - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 636 CONFIGURATION > Network > Interface > Ethernet > lan1 > IPv6 Router
Advertisement Setting
6.2.2 Set Up the 6to4 Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Tunnel > Add, Select
1
Enable. Enter tunnel0 as the Interface Name and select 6to4 as the Tunnel Mode. In the 6to4
Tunnel Parameter section, this example just simply uses the default 6to4 Prefix, 2002:://16.
Enter your Relay Router's IP address (192.88.99.1 in this example). Select wan1 as the
Gateway. Click OK.
Figure 637 CONFIGURATION > Network > Interface > Tunnel
6.2.3 Test the Result
Connect a computer to the ZyWALL/USG's LAN1.
1
Chapter 6 Configure IPv6
ZyWALL/USG Series User's Guide
267
Advertisement
Table of Contents
