Figure 28 CONFIGURATION > Network > Interface > VLAN > vlan1
Figure 29 CONFIGURATION > Network > Interface > VLAN > vlan1:1
1.3.3 Set Up the Routing on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Routing, set Next-Hop Type to be
1
Interface and set Interface to be the vlan1.
Figure 30 CONFIGURATION > Network > Routing
1.3.4 Test the Result
Check the Interface Statistics, you can see vlan1 Status is up, Tx B/s displays the transmission
1
speed and Rx B/s displays the reception speed. Port 5 and Port 6 are configured in the same vlan1
but use different IP addresses.
Chapter 1 Set Up Your Network
ZyWALL/USG Series User's Guide
27