Test The Result - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 644 CONFIGURATION > Network > Routing > Policy Route > IPv6 Configuraiton
6.3.4 Test the Result
Connect a computer to the ZyWALL/USG's LAN1.
1
Enable IPv6 support on your computer. In Windows XP, you need to use the IPv6 install command in
2
a Command Prompt. In Windows 7, IPv6 is supported by default. You can enable IPv6 in the
Control Panel > Network and Sharing Center > Local Area Connection screen.
Your computer should get an IPv6 IP address (starting with 2002:7a64:dcee:1: for this example)
3
from the ZyWALL/USG.
Figure 645 Window 7 > cmd > ipconfig
Use the ping -6 [IPv6 IP address] command in a Command Prompt to test whether you can ping a
4
computer behind ZyWALL/USG_Y. You should get a response.
Chapter 6 Configure IPv6
ZyWALL/USG Series User's Guide
271
Advertisement
Table of Contents
