6.1 How to Set Up IPv6 Interfaces for Pure IPv6 Routing
This example shows how to configure your ZyWALL/USG WAN and LAN interfaces which connects
two IPv6 networks. ZyWALL/USG periodically advertises a network prefix of
2002:1111:1111:1111::/64 to the LAN through router advertisements.
Figure 627 ZyWALL/USG with Pure IPv6 Network Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.13).
6.1.1 Enable the IPv6 on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > System > IPv6 > Global Setting, select the
1
Enable IPv6 and click Apply at the bottom of the screen.
Figure 628 CONFIGURATION > System > IPv6 > Global Setting
6.1.2 Set Up the WAN IPv6 Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Ethernet > wan1.
1
Select Enable Interface and Enable IPv6. Select Enable Stateless Address Auto-
configuration (SLAAC). Click OK.
C
ZyWALL/USG Series User's Guide
262
H A PT ER
Configure IPv6
6