Test The Ipsec Vpn Tunnel - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Then, go to Advanced Settings enable PFS and DPD if you enable both options in the ZyWALL/
5
USG. Set IKE Policy to be the IKE Policy created in Step 2 (found under IKE Policy Link); set
Transform to be the Transform Set created in Step 3 (found under Transform Link) and SA-
Lifetime to be 24 hours.
Click OK. The connection active dialog box appears. Click Activate Connection.
Figure 293 VPN > Site-to-site > IPsec Policies > Advanced Settings
4.4.3 Test the IPSec VPN Tunnel
Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click Connect
1
on the upper bar. The Status connect icon is lit when the interface is connected.
Figure 294 CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time and
2
Inbound(Bytes)/Outbound(Bytes) traffic.
Figure 295 MONITOR > VPN Monitor > IPSec
Go to Cisco VPN > VPN Status > IPsec VPN Status > Active Sessions and check the tunnel
3
Status is up.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
132
Advertisement
Table of Contents
