Set Up The L2Tp Vpn Tunnel On The Windows 10 - ZyXEL Communications ZyWALL 110 Handbook

Figure 549
11 Select Place all certificates in the following store and then click Browse and find Trusted
Root Certification Authorities. Click Next, then click Finish.
Figure 550
Note: Each ZyWALL/USG device has its own self-signed certificate by factory default.
When you reset to default configuration file, the original self-signed certificate is
erased, and a new self-signed certificate will be created when the ZyWALL/USG
boots the next time.

5.4.3 Set Up the L2TP VPN Tunnel on the Windows 10

To configure L2TP VPN in Windows 10 operating system, go to Start > Settings > Network &
1
Internet > VPN > Add a VPN Connection and configure as follows.
VPN Provider set to Windows (built-in).
Configure Connection name for you to identify the VPN configuration.
Set Server name or address to be the ZyWALL/USG's WAN IP address (172.124.163.150 in this
example).
Select VPN type to Layer 2 Tunneling Protocol with IPsec (L2TP/IPsec).
Enter User name and Password which the same as Allowed User created in ZyWALL/USG
(L2TP_Remote_Users/zyx168 in this example).
Chapter 5 Create Client-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
228