Test The Ipsec Vpn Tunnel - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 425 CONFIGURATION > VPN > IPSec VPN > VPN Connection > Create new Object
Set Local Policy to be Branch_B and Remote Policy to HQ-to-Branch_A which are newly
created. Click OK.
Figure 426 CONFIGURATION > VPN > IPSec VPN > VPN Connection > Policy
4.8.14 Test the IPSec VPN Tunnel
Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click Connect
1
on the upper bar. The Status connect icon is lit when the interface is connected.
Figure 427 Hub_HQ > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Figure 428 Spoke_Branch_A > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Figure 429 Spoke_Branch_B > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time and the
2
Inbound(Bytes)/Outbound(Bytes) traffic. Click Connectivity Check to verify the result of
ICMP Connectivity.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
184
Advertisement
Table of Contents
