YASKAWA DX200 Instructions Manual page 7

170625-1CD
ES200RD II
Definition of Terms Used In this Manual
Registered Trademark
Definition of Terms Used In this Manual
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the DX200 after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the
DX200 Instructions before operating the manipulator:
The MOTOMAN is the YASKAWA industrial robot product.
The MOTOMAN usually consists of the manipulator, the controller, the
programming pendant, and supply cables.
In this manual, the equipment is designated as follows:
Equipment
DX200 controller
DX200 programming pendant
Cable between the manipulator and the
controller
In this manual, names of companies, corporations, or products are
trademarks, registered trademarks, or bland names for each company or
corporation. The indications of (R) and
vii
CAUTION
Manual Designation
DX200
Programming pendant
Manipulator cable
TM
are omitted.
HW1482737
7 of 100