Erasing Peripheral Shadows On The Image (Erase) - Sharp MX-M950 Software Manual

ERASING PERIPHERAL SHADOWS ON THE
IMAGE (Erase)
The erase function is used to erase shadows on images produced when scanning thick originals or books. (This function
erases the parts of the image where shadows tend to form. The function does not detect shadows and erase only the
shadows.)
Scanning a thick book
Shadows appear here
Erase modes
Edge Erase
• Shadows at the edges of the original can also be erased when the automatic document feeder is used.
• When using USB memory mode, connect the USB memory device to the machine before performing the procedure below.
Place the original.
1
Place the original face up in the document feeder tray, or face down on the document glass.
Specify the destination.
☞
2. ENTERING DESTINATIONS
2
When scanning to USB memory in USB memory mode, there is no need to specify the destination. Go to step 3.
Center Erase
(page 25)
92
Not using the erase
function
Shadows appear in the
image.
Edge + Center Erase
Using the erase
function
No shadows appear.
Side Erase