•
Uniformly tighten the fasteners securing the
manifold to the cylinder head.
1
•
Tighten clamp (1) for the silencer, making sure
that the clamp is correctly positioned (arrow).
•
Connect the plug for the oxygen sensor.
•
Using a cable tie (arrow), secure the oxygen sen-
sor cable and the cable for the side-stand switch
to the frame truss.
–
Install engine guard (
a
X
Tightening torques:
Oxygen sensor to exhaust............................ 45 Nm
Exhaust manifold to cylinder head................ 20 Nm
Clamp for silencer ........................................ 55 Nm
Engine guard to frame .................................... 9 Nm
E180021
E180010
46.8).
Replacing guard for silencer
18 12 212
–
Remove the lid of the glove compartment.
•
Remove the fastener (arrow) securing the turn in-
dicator at the handle and push the turn indicator
aside.
•
Remove the fasteners securing the guard to
silencer (2) and remove guard complete with
damper washers (3).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Guard to silencer ........................................... 9 Nm
E630010
2
3
E180031
18.7