Removing And Installing Needle Roller Races In Rear Swinging Fork - BMW F 650 GS Repair Manual

1
5
•
Remove nut (1) at swinging-fork pivot shaft (3).
•
Remove swinging-fork pivot shaft (3).
•
Pull the swinging fork to the rear to remove; re-
move thrust washers (2).
•
Remove chain guide rail, if necessary.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Grease needle bearings with Shell Retinax EP2.
– Adjust chain tension (
a
X
Tightening torques:
Swinging-fork pivot shaft ............................ 100 Nm
Reaction link to swinging fork....................... 41 Nm
Rear quick-release axle.............................. 100 Nm
Wheel cover bracket to swinging fork............. 9 Nm
ABS sensor to holder ..................................... 9 Nm
4
00.46).
2
Removing and installing nee-
33 17 373
dle roller races in rear swinging fork
Removing needle roller races
•
Remove bearing bushes (4) and sealing rings (5)
from swinging fork.
e
Important:
Protect mating faces (arrow) of the swinging fork
from scratches by covering with masking tape or
similar.
•
Drive needle roller races out of rear swinging fork
with drift, BMW No. 33 6 661.
3
E330020
33 6 661
F330100
33.7