Removing ignition magneto
12 11 070
e
Important:
Never disconnect plug connection on ignition sys-
tem while engine is running.
Removing right engine hous-
11 14 859
ing cover
3
•
Remove fasteners of cable cover (1).
•
Disconnect the plug of the stator (4) from
connector (2).
•
Disconnect the plug of ignition trigger (3).
•
Remove fastener from right engine housing cov-
er.
12 5 500
•
Remove the central locking screw, insert and
tighten handle, BMW No. 12 5 500.
4
1
•
2
E120030
•
•
L
Use temperature measuring device,
BMW No. 00 1 900, to check the temperature.
•
E110180
Remove the cover, noting the thrust
washer (arrow).
Unscrew hex nut.
Heat hub to 80 °C (176 °F).
Note:
Using puller, BMW No. 12 5 510, pull off magnet
rotor.
E110190
12 5 510
E110210
12.7