Removing And Installing Rear Wheel - BMW F 650 GS Repair Manual

36 31 851 Installing wheel bearings
•
Clean the bearing seats.
•
Drive in the left-hand wheel bearing with drift,
BMW No. 36 6 600.
•
Install the spacer bushing.
•
Drive in the right-hand wheel bearing with drift,
BMW No. 36 6 600, until seated, making sure
that the load is supported only on the left-hand
wheel bearing.
L
Note:
The left-hand bearing must be seated on the stop in
the wheel hub. The spacer sleeve between the two
bearings should have no more than minimal axial
clearance, if any.
•
Drive in the new shaft sealing ring with a drift,
BMW No. 36 6 600.
– Check gap of ABS sensor and adjust if neces-
sary ( 34.20).
a
Removing and installing rear
36 30 320
wheel
1
4
•
Place motorcycle on its centre stand.
•
Remove wheel cover (1) together with chain
guard (2).
•
Remove fastener (6) and remove ABS sensor (5)
from its holder.
•
Press the brake caliper against the brake disc in
order to force the piston back.
•
Loosen chain tensioning screws (4) on left and
right sides.
•
Unscrew quick-release axle nut (3).
•
Remove chain from chainwheel.
•
Remove quick-release axle.
e
Important:
2
Do not operate the brake pedal when the wheel is
removed.
•
Pull the wheel to the rear to remove.
•
Installation is the reverse of the removal proce-
3
dure: pay particular attention to the following.
•
Clean the quick-release axle and the contact
face of the shaft sealing ring and grease them
with Optimoly TA.
– Adjust chain tension (
– Check gap of speed/ABS sensor and adjust if
necessary (
X
E360060
Tightening torques:
Quick-release axle ..................................... 100 Nm
Wheel cover bracket to swinging fork............. 9 Nm
ABS sensor to holder ..................................... 9 Nm
6
00.47).
a
34.21).
a
5
E360080
36.7