Removing and installing
11 11 200
grooved ball bearings of balancing
shaft
L
Note:
To protect the gasket surfaces of the engine block,
place the old gasket under the bearing puller.
Always renew the mainshaft sealing ring.
•
Heat the left of the engine block to 80 — 100 °C
(176 — 212 °F).
•
Using bearing puller plate, BMW No. 11 6 561,
spindle, BMW No. 11 6 562, and spreader
sleeve, BMW No. 11 6 563, pull off the ball bear-
ing.
•
Heat the right of the engine block to 80 - 100 °C
(176 - 212 °F).
•
Using bearing puller plate, BMW No. 11 6 561,
spindle, BMW No. 11 6 562, and spreader
sleeve, BMW No. 11 6 563, pull off the ball bear-
ing.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
The sealed ends of the cage must point outwards.
•
To install the ball bearing, heat the engine block
to 80 - 100 °C (176 - 212 °F) and spray the ball
bearing with BMW chilling spray.
Removing and installing main
11 21 001
bearings
•
Check main bearings for signs of damage and
wear.
Removal
•
Heat the engine housing to 100 °C (212 °F).
•
Drive out the bearing bushings with drift,
BMW No. 11 0 541, and drift,
BMW No. 00 5 500.
00 5 500
11 0 541
F110480
11.41