•
Dispose of the packing materials in an environ-
mentally responsible manner as described in
Circular 23/91 - Sales.
•
Check the contents of the enclosed package:
–
Front mudguard with fasteners and washers
–
Windshield
–
Mirrors with clamping screws and nuts
–
Handlebar weights with screws
–
Spacer sleeve, spacer
–
four washers for front mudguard
–
Rider's Manual
–
Service and Technical booklet
–
Booklet listing service centres in Europe
–
BMW emergency service sticker
–
Handling instructions for batteries
Inspecting motorcycle for damage
•
Check for defects.
•
Use the "express handling service" to notify
BMW AG Sparte Motorrad, UX-VS-1
Fax: 00 49 89 382-33220
•
Rectify the fault.
•
If parts are needed, order them by using the
electronic parts list.
•
Costs are to be processed by the warranty claim
system (stage 4).
Defect codes:
–
Parts missing 10 01 00 00 00
–
Parts damaged 10 02 00 00 00
–
Incorrect parts delivered 10 03 00 00 00
•
If the parts that are needed do not appear in the
electronic parts list (e.g. parts for official-user
motorcycles),
send an order form to:
Fax number 030-3396-2262
Installing remaining items on
motorcycle
Installing the front wheel
e
Caution:
Take care not to damage the ABS sensor, sensor
ring, brake disc and brake pads when installing.
•
Raise front of motorcycle (e.g. with crane).
•
Clean the quick-release axle and the contact
face of the shaft sealing ring and grease them
with Optimoly TA.
00.16
2
•
Install spacer sleeve (1).
•
Insert the front wheel between the telescopic
fork legs.
•
Install quick-release axle (2) with spacer (3).
•
Tighten the quick-release axle (arrow).
•
Lower the front wheel to the ground, compress
the front suspension firmly several times.
•
Tighten clamping screw (4) securing the quick-
release axle.
X
Tightening torques:
Quick-release axle ....................................... 45 Nm
Clamping screw ........................................... 21 Nm
1
3
E000390
4
E000400