Removing And Installing Lock For Rear Stowage Compartment; Removing And Installing Lock Barrel For Fuel Tank Filler Cap; Removing And Installing Lock Barrel - BMW F 650 GS Repair Manual

•
Remove the shanks of the non-removable
screws.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Tighten the non-removable screws with socket
wrench insert, BMW No. 51 0 530.
d
Warning:
Begin by tightening the front securing screws (as
viewed in the forward direction of travel) of the clamp
blocks, then tighten the rear securing screws.
X
Tightening torque:
Ignition/steering lock to fork bridge .............. 21 Nm
Hexagon nut to counter-tube ....................... 65 Nm
Clamp screws for fork bridge ....................... 23 Nm
Handlebars to fork bridge............................. 23 Nm

Removing and installing lock barrel

– Place motorcycle on its centre stand.
•
Turn the handlebars to the left.
•
Turn the ignition key to the ON position.
•
Press in the safety catch by inserting a suitable
tool through the opening (arrow), e.g. a piece of
wire.
•
Pull the lock barrel out with the ignition key.
51.6
Removing and installing lock for
rear stowage compartment
– Place motorcycle on its centre stand.
•
Remove the lid of the rear stowage compart-
ment.
•
Clamp the lid in a vise with protective jaws.
2
•
Use a punch of suitable diameter to drive out
pin (1).
•
Remove latch (2).
•
Press out the lock.
•
Installation is the reverse of the removal proce-
dure.
Removing and installing lock
51 25 030
barrel for fuel tank filler cap
L
Note:
Make sure that screws do not fall into fuel tank: cov-
er fuel tank filler neck with cloth.
E510040
•
Open the fuel filler cap.
•
Remove the bottom part of the filler cap.
1
E510020