Removing and installing cyl-
11 12 116
inder head, engine installed
L
Note:
If an engine failure occurs, the oil tank and oil lines
must be cleaned with the material used for this pur-
pose in the workshop, and then blown through with
compressed air.
Preparatory work
–
Remove left, right and centre covers (
–
Remove battery (
61.10).
a
–
Drain coolant (
00.30).
a
•
Drain the engine oil from the oil tank.
–
Remove engine guard (
–
Remove starter (
12.9).
a
–
Remove exhaust manifold and oxygen sensor
(
18.6).
a
–
Expose radiator and remove fan (
–
Remove intake air pipe (
–
Remove intake air silencer (
•
Remove the battery box.
•
Remove circlip securing throttle cable to throttle
valve stub and disengage the throttle cable from
the guide.
•
Disengage throttle cable from adapter.
•
Disconnect plugs at throttle valve stub.
•
Remove the intake pipe from the cylinder head
and lay it carefully to one side, complete with the
throttle valve stub.
•
Slacken the fastener securing the lid of the elec-
tronic equipment box.
•
Disengage the cover from the anchorages on the
main frame on each side and remove.
•
Disconnect the starter coil at the plug.
•
Remove the fastener securing the ignition-coil
bracket and remove the ignition coil complete
with bracket.
11.16
46.5).
a
46.8).
a
17.10).
a
13.5).
a
13.6).
a