Important Information - ATTACK PELLET 30 AUTOMATIC PLUS Instructions For Use Manual

IMPORTANT INFORMATION:

• Boiler for wood pellet combustion.
• Installation, test heat-up and training of attendance must be performed by trained
service technician, who has to fill-in the protocol about boiler installation.
• Recommended boiler operation temperature is 65 – 80 °C. Lower operation
temperature may cause creation of condensate, shorter life-time of boiler and warranty
expiration.
• The only fuel to use are pellets, adequate to the approved fuel specification.
• Appropriate boiler output represents very important condition of economic
operation and correct boiler function. Nominal boiler output has to be adequate
to thermal losses of the heated object.
Prosím prečítajte si tento návod pred uvedením kotla do prevádzky.
•
Keep this manual for attendance on a suitable place in the boiler room. It is
recommended to keep it in a plastic pack and to hang it on a visible place on the
wall to be reached by techni-cian, when doing service in your boiler room.
•
Boiler door and connections between boiler and chimney have to be airtight.
•
Overpressure in combustion chamber should be at least 5 pascal (0,5 mm of water
column, resp. 0,05 hPa).
•
The PEL30PLUS appliance is intended for combustion of wood pellets and it
cannot be used for combustion of other fuel types.
•
The PEL30PLUS appliance for pellet combustion can be installed in a boiler room
only, in conformity with prescriptions of the local fire safety / construction
authority.
WARRANTY FOR BOILER IS NOT VALID IF:
•
it is not operated with prescribed fuel - pellets adequate to the approved fuel
specification.
•
there is no mixing device Regumat ATTACK-OVENTROP installed in the
system to en-sure temperature of the boiler return water over 65°C.
WARNING SIGN
This warning sign appears in the operating instructions whenever it is necessary to
point out that personal injury and damage to property can occur if these instructions
are not followed exactly.
Two types of warnings are used in this manual:
WARNING – warns about dangerous situations and situations that may cause
health injury or damage by breaking the indespansable measures.
ATTENTION – warns about less dangerous procedures that may cause safety
hazard or damage of property.
2