Nd Transfer Roller - Samsung CLX-9350ND Service Manual

● Code :
M2-1331
M2-1333
M2-1334
● Symptom / Cause : Paper transport jam (paper Inp
- The paper has not reached the fuser out sensor with
- The fuser out sensor is not off within normal time afte
● Troubleshooting method :
1. Open the side door. Remove the jammed paper. p
Close the side door. After warm up, if same jam occ
2. If there is any obstacles between the tray1 feed rolle
nd
3. If the 2 transfer roller or assembly is damaged, rep
4. If the problem persists, separate the side unit from s 4 If th bl
5. If Cam, lever, spring of the 2
6. If the actuator-fuser out, guide-face up exit are dama
7. Enter the diagnostic mode, and execute the fuser ou g
Fix the actuator and be the paper at sensor. If "Witho
sensor.
8. Check if the fuser out sensor connector is connected
9. Replace the Joint PBA of the side unit.
10. Replace the harness of the side unit.
11. Check if the connector of the engine controller is co
12. Replace the engine controller PBA.
● Replacement part ● Replacement part
- JC95-01038A : COVER-SIDE TRANSFER ROLLER
- JC92-02233A : SIDE JOINT
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7. Troubles
● Error message :
Paper jam inside of m
j
i t t th id
nd
transfer roller engage
,
shooting
machine.
put section)
hin normal time after passing the regi sensor.
er the fuser out sensor on.
p p
curs, check the following.
er and the regi roller, remove it.
place it.
it f set. And check the following. t A d h
e device are damaged, replace them.
aged, replace them.
ut sensor test.
out paper" message is displayed, replace the
d properly. Reconnect the connector.
onnected properly. Reconnect the connector.
7-8 84
k th f ll i
SAMSUNG ELECTRONICS