Samsung CLX-9350ND Service Manual page 427

● Code :
M2-2313
● Symptom / Cause : Paper transport jam (paper I
- The paper has not reached the regi sensor within nor
● Troubleshooting method :
1. Open the side door. Remove the jammed paper.
Close the side door. After warm up, if same jam occ
2. If there is any obstacles between the duplex feed ro
3. Check if the reflective sensor connector, junction co
Reconnect it.
4. Enter the diagnostic mode, and execute the reflectiv
Be the paper at sensor. If "Without paper" message i B th t
5. Enter the diagnostic mode, and execute the pick up
If the motor is not working, replace it.
6. Check if the regi connector on the engine controller
Reconnect it.
7. Replace the engine controller PBA.
● Replacement part
- JC31-00132A : MOTOR STEP
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7. Troubles
● Error message :
Paper jam at the insi
If "With t "
shooting
ide of duplex path.
nput section)
rmal time after passing the duplex jam 2 sensor.
curs, check the following.
ller and the regi roller, remove it.
onnector are connected properly.
ve sensor test.
is displayed, replace the sensor. i i di l d l
drive motor test.
is connected properly.
7-8 87
th
SAMSUNG ELECTRONICS