Samsung CLX-9350ND Service Manual page 431

● Code :
M3-2330
● Symptom / Cause :
Too much paper in output bin tray (paper out put secti
- The bin full sensor actuator or sensor is defective.
● Troubleshooting method :
1. If the face up actuator doesn't come down or come d
the side unit. Reassemble the actuator or replace it.
2. Enter the diagnostic mode, and execute the face up
When lifting the bin full actuator, if "without paper" is
reconnect the connector.
3. If the photo interrupter is broken away from the side
and reassemble the photo interrupter. and reassemble the photo interrupter
4. Check if the photo interrupter connector, junction co
If the connector is unplugged, remove exit unit and r
5. Replace the Side Joint board.
● Replacement part
- JC92-02233A : SIDE JOINT
Service Manual
CLX-9250/9350 series
7. Troubles shooting
● Error message :
Output tray (face up) ) is full. Remove printed media.
ion)
down slowly, remove the black cover on the top of
p
bin full sensor test.
s displayed, replace the photo interrupter or
e unit, remove black cover on the top of the side unit
onnector are connected properly.
reconnect the connector.
7-9 91
SAMSUNG ELECTRONICS