Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the graft retry timer.
Configuring IPv6 PIM-SM
IPv6 PIM-SM configuration task list
Task at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
NOTE:
Perform at least one of the tasks.
In a network with a static RP, skip the task of configuring a BSR.
Configure a BSR:
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure IPv6 PIM-SM, configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
Enabling IPv6 PIM-SM
Enable IPv6 multicast routing before configuring IPv6 PIM.
With IPv6 PIM-SM enabled on interfaces, routers can establish IPv6 PIM neighbor relationship and
process IPv6 PIM messages from their IPv6 PIM neighbors. When you deploy an IPv6 PIM-SM domain,
HP recommends enabling IPv6 PIM-SM on all non-border interfaces.
IMPORTANT:
All the interfaces on the same router must operate in the same IPv6 PIM mode.
Enabling IPv6 PIM-SM
Configuring an
RP:
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling the BSM semantic fragmentation function
Configuring IPv6 multicast source registration
Configuring switchover to SPT
Configuring common IPv6 PIM features
Command
system-view
interface interface-type
interface-number
ipv6 pim timer graft-retry interval
151
Remarks
N/A
N/A
By default, the graft retry timer is 3
seconds.