Configuring Mld Snooping Policies; Configuring An Ipv6 Multicast Group Filter - HP 6125XLG Configuration Manual

To enable MLD snooping fast-leave processing on a port:
Step
1. Enter system view.
2. Enter Ethernet interface view
or aggregate interface view.
3. Enable MLD snooping
fast-leave processing on the
port.

Configuring MLD snooping policies

Before you configure MLD snooping policies, complete the following tasks:
Enable MLD snooping for the VLAN.
•
• Determine the ACL used as the IPv6 multicast group filter.
Determine the maximum number of IPv6 multicast groups that a port can join.
•

Configuring an IPv6 multicast group filter

When you configure an IPv6 multicast group filter, follow these guidelines:
This configuration is effective for the IPv6 multicast groups that the port dynamically joins. If you
•
configure the port as a static member port for an IPv6 multicast group, this configuration is not
effective for the IPv6 multicast group.
You can configure an IPv6 multicast filter either for the current port in proper interface view or
•
globally for all ports in MLD-snooping view. If the configurations are made in both interface view
and MLD-snooping view, the configuration made in interface view takes priority.
Configuring an IPv6 multicast group filter globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Configure an IPv6 multicast
group filter globally.
Configuring an IPv6 multicast group filter on a port
Step
1. Enter system view.
2. Enter Ethernet interface view
or aggregate interface view.
Command
system-view
interface interface-type
interface-number
mld-snooping fast-leave [ vlan
vlan-list ]
Command
system-view
mld-snooping
group-policy acl6-number [ vlan
vlan-list ]
Command
system-view
interface interface-type
interface-number
108
Remarks
N/A
N/A
By default, MLD snooping
fast-leave processing is disabled.
Remarks
N/A
N/A
By default, no IPv6 multicast group
filter is configured. A host can join
any valid IPv6 multicast group.
Remarks
N/A
N/A