Loop Protection - GE T1000 Technical Manual

GE Reason Switches
5

Loop Protection

246
This section describes the monitoring possibilities for Loop Protection via Web
Interface in Reason Switches.
If desired to update Reason Switches web screen automatically, check the Auto
Refresh checkbox on top to perform it. If selected, monitoring web page will be
updated after 3 seconds of the last update automatically.

Loop Protection:
Loop Protection Status monitoring option allows user to view basic information about
loop protection running in Reason Switches. Information allowed is as follows:
Port number;
o
Action configured to be executed in the interface if a loop is
o
detected, which can be Shutdown, Log and Shutdown+Log;
Transmit, which represents if the messages sending throughout
o
the network is enabled or not;
Loops, which represents total loops detected at the port since
o
function was enabled;
Status, which represents loop detection status at a given port.
o
Allowed values are Up and Down, where Up represents link up and
Down represents link down. If a link is disabled because of loop
detected, the timestamp of the last loop detected is represented at
the following column;
Time of Last Loop, which represents the timestamp of the last
o
detected loop. Timestamp shown in this column is based on
system's internal clock.
Chapter 8 – Monitoring
REASON SWITCHES-TM-EN-3