Compliance - GE T1000 Technical Manual

Chapter 1 – Introduction
6

Compliance

6.1 Standard Compliance
6.2 EMC Compliance
6.3 Product Safety
REASON SWITCHES-TM-EN-3
The device has undergone a range of extensive testing and certification processes to
ensure and prove compatibility with all target markets. A detailed description of
these criteria can be found in the Technical Specifications chapter.
Compliance with the European Commission Directive on EMC and LVD is
demonstrated by self-certification against international standards.
Compliance with IEC 60255-26:2013 was used to establish conformity.
Compliance with IEC 60255-27:2013 was used to establish conformity.
Protective Class
IEC60255-27:2013 Protective Class 1. This equipment requires a protective conductor
(ground) to ensure user safety.
Installation category
IEC 60255-27:2013 Installation category III (Overvoltage Category III). Equipment in
this category is qualification tested at 5kV peak, 1.2/50 µS, 500 Ohms, 0.5 J, between
all supply circuits and ground, and also between independent circuits.
Environment
IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-30, IEC 60068-2-14, IEC 60255-21-1, IEC
60255-21-2. The equipment is intended for indoor use only. If it is required for use in
an outdoor environment, it must be mounted in a specific cabinet or housing which
will enable it to meet the requirements of IEC 60529 with the classification of degree
of protection IP54.
GE Reason Switches
23