GE T1000 Technical Manual page 205

Chapter 7 – Configuration
REASON SWITCHES-TM-EN-3
Specific: only ethertype configured will be
o
used at this QCE, that is, this entry will map
frames based in many parameters including
its ethertype value. Values must be inserted
in hexadecimal format.

LLC: indicates which LLC values will be allowed in
this QCE. When selected, the LLC Parameters will
be displayed. Possible configuration is as follows:
DSAP Address: indicates which filter should
o
be applied based on the Destination Service
Access Point (DSAP) field at the frame.
Possible configuration is as follows:
Any:

incoming frames will be used
at this QCE;
 Specific: only DSAP configured
will be used at this QCE, that is,
this entry will map frames
based in many parameters
including
Values must be inserted in
hexadecimal format.
SSAP Address: indicates which filter
o
should be applied based on the Source
Service Access Point (SSAP) field at the
frame. Possible configuration is as
follows:
Any:

incoming frames will be used
at this QCE;
 Specific: only SSAP configured
will be used at this QCE, that is,
this entry will map frames
based in many parameters
including its SSAP value. Values
must
hexadecimal format.
Control: indicates which filter should be
o
applied based on the Control field at the
LLC bytes on the frame. Possible
configuration is as follows:
Any:

incoming frames will be used
at this QCE;
Specific: only Control values

configured will be used at this
QCE, that is, this entry will map
GE Reason Switches
indicates that all
its DSAP value.
indicates that all
be inserted in
indicates that all
205