Rstp Configuring In A Ring Network Topology - GE T1000 Technical Manual

Chapter 7 – Configuration
14.2

RSTP Configuring in a Ring Network Topology

REASON SWITCHES-TM-EN-3


Thus, configuration of the port where the switches are connected should be as
follows.








These VLAN configuration settings should be enough to guarantee that only
equipment expecting to receive a given traffic will receive it. Besides, segregation of
traffic would increase the reliability of the network, as congestion on one VLAN would
not affect other ones.
Consider the situation given figure below.
Filtering ingress process: this port should accept both
untagged and tagged frames;
Egress process: egress process should be set to Untag
only frames with Port VLAN identifier.
Port mode should be chosen as Trunk port;
Port VLAN should be 1;
For trunk ports, Port Type is not allowed to be changed
from C-Port;
For trunk ports, Ingress Filtering is not allowed to be
changed from enabled;
For trunk ports, Ingress Acceptance is not allowed to be
changed from Tagged and Untagged;
Egress tagging should be chosen as Untag Port VLAN;
Allowed VLANs should be 1, 10, 20, 30;
No forbidden VLANs should be configured.
GE Reason Switches
229